← Door installation services

Scottsdale · Door Installation

Door installation in Scottsdale by an owner-operated finish carpenter.

Scottsdale homes expect doors that hang dead-plumb, swing without a catch, and meet casing and hardware with clean, even reveals. Retro Fit Installation LLC installs interior, solid-core, and front doors as finish carpentry — the slab, jamb, hardware, and surrounding trim are set to line up and stay that way.

Owner-performed by Devin Nelson — the person you talk to is the person doing the install. Licensed Arizona finish carpenter · AZ ROC R-60 #346885 · Bonded & insured.
Bypass door installation and casing detail from the E Calle Ventura project in Scottsdale by Retro Fit Installation LLC

What Gets Installed

Door installation for Scottsdale homes and remodels.

From a single front door to a full interior package on a custom build, each door is treated as finish work — measured to the opening, set true, and tied cleanly into the surrounding casing and hardware.

Interior doors

Bedroom, bathroom, hallway, closet, and pantry doors hung with consistent reveals, quiet operation, and hardware that lines up room to room.

Solid-core & single-panel

Heavier solid-core and single-panel slabs are set with proper hinge backing and screw purchase so they hang true and don't sag over time.

Front & exterior doors

Entry and front doors are fit for plumb, even reveals, weather-seal contact, threshold fit, and a latch and deadbolt that engage cleanly.

Prehung & slab conditions

Prehung units are shimmed square in the rough opening; slabs into existing jambs get hinge and bore prep, mortising, and edge easing to fit.

Closet & bypass doors

Bypass, bifold, and closet openings get track layout, guide alignment, and panel adjustment so they run smooth and sit flush.

Casing, jamb & hardware

Jamb detailing, straight casing, hinges, levers, locksets, stops, and pulls installed with tight miters and consistent layout.

Done Right

What a proper door install actually includes.

The difference between a door that was hung and a door that was installed well shows up in the details — the parts most people feel every day without naming them.

Even reveal margins

Consistent gaps down the hinge side, latch side, and head so the door reads straight and closes without rubbing.

Plumb, level, square jamb

The jamb is shimmed and fastened plumb and level so the slab holds its position instead of drifting open or swinging shut.

Hinge & strike alignment

Hinges mortised to depth and strikes set so the latch catches on the first try and the door sits flush to the stop.

Protected finishes

Floors, casing, and adjacent surfaces are covered before cutting or fitting, so new finishes stay clean through the install.

Smooth swing & latch

The door is cycled and dialed in so it swings freely, holds where you leave it, and latches and locks without force.

Clean casing tie-in

Casing and trim are returned to the jamb with tight joints so the finished opening looks intentional, not patched.

Scottsdale Homes

Finish standards for Scottsdale custom homes and designer remodels.

From the golf communities of North Scottsdale to remodels in Old Town and the McCormick Ranch corridor, Scottsdale doors are seen up close and expected to read perfectly. Tall interior slabs, statement entry doors, and designer hardware only look right when the reveals are even and the hardware sits true. Work is owner-performed and backed by a 2-year workmanship warranty.

Custom & luxury homes

Taller 8-foot and oversized interior doors are set with proper hinge backing so heavier slabs hang dead-plumb and stay that way, with reveals matched opening to opening.

Working with designers & builders

Specified slabs, jamb details, and hardware are installed to the drawings and layout your designer or builder set, with clean casing tie-ins on the visible openings.

Statement entry doors

Front and oversized entry doors are fit for even reveals, smooth swing, and hardware that engages cleanly — the first thing guests touch, dialed in.

Your Door or Ours to Coordinate

Already have a door — or still choosing one?

Plenty of Scottsdale homeowners have already found the front or interior door they want and just need it installed correctly. Others are still deciding. Both are easy to work with.

You supply the door

Customer-provided slabs and prehung units are welcome. Bring the door and it's fit, set, and adjusted to the opening so the swing, latch, and reveals come out clean.

Still choosing the door

If you haven't bought yet, the estimate is a good time to talk through sizing, swing direction, slab type, and hardware so what you order actually fits the opening.

Install or Repair

Not every door needs replacing.

If an existing door is sound and just out of adjustment, a repair is often the cleaner call. New construction, damaged slabs, resized openings, and design changes are where a fresh install makes sense.

Have a door that sticks, sags, or won't latch rather than one to install? See door repair in Scottsdale. For the full overview across the valley, see the main door installation page.

How It Works

A straightforward door installation process.

Every install follows the same order so the opening is right before the door goes in and your finishes stay protected throughout.

1 · Review the opening

The rough opening or existing jamb is measured and checked for square, plumb, and size against the door being installed.

2 · Confirm door & swing

Door type, hardware, hinge side, and swing direction are confirmed so the finished door works the way the room needs.

3 · Protect finishes

Floors, casing, and nearby surfaces are covered before any cutting, mortising, or fitting begins.

4 · Install & adjust

The jamb is set plumb and level, the slab hung, hinges and strikes aligned, and casing and hardware fit for even reveals.

5 · Final operation check

The door is cycled and the swing, latch, lock, and margins are verified before the job is called done.

Reviews

Rated 5.0 on Google.

Several of these reviews are from door installation and front-door work — the exact scope this page is about.

5.0 11 Google reviews
  • Devin Nelson does amazing work, great craftsmanship, diligent through every step of the process! Has great communication and I would highly recommend using him for any upcoming projects you might have!
    Chase WilliamsGoogle review
  • Retrofit has done various projects in my condo from installing new doors to replacing and custom fitting vanities… their professionalism is unmatched and the job always exceeds expectations. Pricing is fair and they are always transparent.
    Amber AGoogle review
  • The best there is!! Highly recommend! Totally transformed our front door! We couldn’t believe it was the same door!
    Cheyenne FitchGoogle review

Service Area

Door installation in Scottsdale and nearby.

Retro Fit Installation LLC is a Tempe-based door installer serving Scottsdale, North Scottsdale, and Paradise Valley along with Cave Creek, Phoenix, Mesa, Gilbert, and the wider East Valley. Working on more than doors? These finish carpentry pages are closely related.

FAQ

Door installation in Scottsdale — common questions.

How much does door installation cost in Scottsdale?

Every install is quoted after looking at the opening, the door type, the hardware, and how many doors are involved. A single statement entry door is a different job than a full interior package across a custom home. Send photos and the details and Devin follows up with an estimate.

Do you install tall or oversized interior doors?

Yes. Taller 8-foot and oversized slabs — common in Scottsdale custom homes — are hung with proper hinge backing and screw purchase so the extra weight doesn’t cause sag, and the reveals stay even from top to bottom.

Do you install interior door packages for a whole custom home or remodel?

Yes. Interior door packages for custom homes and remodels are core work, from bedroom and bathroom doors to closet, pantry, and bypass openings, all set with consistent margins and matching hardware layout across every room.

Can you work from a designer’s or builder’s specifications?

Yes. When a designer or builder has specified the slabs, jamb detail, and hardware, the doors are installed to that layout and drawing set, with clean casing tie-ins on the visible openings that matter most in a Scottsdale home.

Are you licensed, bonded, and insured?

Yes. Retro Fit Installation LLC is a licensed Arizona finish carpenter, AZ ROC R-60 #346885, bonded and insured, and installs are backed by a 2-year workmanship warranty. Work is owner-performed by Devin Nelson, so the person you talk to is the person doing the install.

How do I get a door installation estimate in Scottsdale?

Call or text 928-699-2638, or use the contact form with photos, the door type, the quantity, and any material details. Devin reviews each Scottsdale request personally and responds with next steps and an estimate.

Need a door installed in Scottsdale?

Send photos, the door type, the quantity, and any material details you have. Devin will review the scope and respond with next steps and an estimate.

Request a Free Estimate